Att E560-1 Bedienungsanleitung PDF herunterladen (Seite 7)

You can re-register handsets after de-registering from the base.

Or you can re-register handsets to a new base unit, if you have

replaced your base unit for any reason.

To re-register a handset:

• Make sure your handset batteries are properly installed and

charged.

• Your handset will display “SEARCHING...”

• Press and hold the

SELECT key until the handset displays

“ENTER BASE ID”.

• Enter the 15 digit Base ID number from the bottom of the

base.

• Press SELECT to accept the new code and complete

re-registration.

To re-register a handset to a new base unit:

• Make sure your handset batteries are properly installed and

charged.

• Unplug the old base unit

• Install the new base unit by plugging it into the electrical

outlet and phone jack

• Your handset will display “SEARCHING...”

• Press and hold the

SELECT key until the handset displays

“ENTER BASE ID”.

• Enter the new15-digit Base ID number from the bottom of

the new base unit.

• Press SELECT to accept the new code and complete

re-registration.

NOTE:

If an invalid base ID code is entered you will hear an error tone and the

handset will continue to display “ENTER BASE ID”. To make corrections while

entering the code, you can erase digits by pressing the DELETE key.

Once a valid base ID code is entered and accepted by the base

unit, the new handset will be assigned the next available handset

number (HS1, HS2, HS3, HS4).You can register a maximum of

four handsets per base unit.

Re-Registering a Handset

91-000341-010-000-E560-1 Manual draft.qxd 2/13/1950 7:21 PM Page 7

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Att E560-1 Bedienungsanleitung Seite 7