Att 5635 Bedienungsanleitung

CORDLESS ANSWERING SYSTEM 5635• Installation• Telephone Operation• Memory Dialing• Answering System• At the Base• Away From the BaseInstallationTa

While the system is taking a call, the Message Window displays “-.” After a message is recorded, thedisplay changes to show the total number of recor

C (steady) Change function is active C (followed by 0-9) Displaying current channel number P Reviewing your announcement –OR- Temporary display w

Saving MessagesThe system saves your messages automatically if you do not delete them.NOTE: The system can save about 12 minutes of messages. When me

Screening Incoming CallsTo screen calls, adjust SPEAKER VOLUME so that you can hear the caller’s voice.If you decide to take a call, either use the co

If it doesn’t receive any instructions in a few seconds, the system will automatically play all of yourmessages for you. First Mailbox 1 followed by

If you enter an invalid code, the system will beep five times.NOTE: If AC power fails and there are no base batteries installed, or the batteries are

You can work with the clock setting any time after the system has given you the two-beep signal to indicatethat it is ready to accept a command.Review

3. Speak into the phone in a normal tone of voice. Just as with messages, the system will accept memosup to two minutes in length.4. To stop recordin

1. After the two-beep signal which indicates that it is ready to accept a command, press and release 6 then#.2. The system beeps once and “L” will be

If the batteries don’t charge properlyThe batteries can be recharged many, many times, but if you get a low battery signal even after 10 hours ofcharg

After the batteries are charged, pick up the handset and extend both the handset and the base antennas.Now press PHONE on the handset. The PHONE Lig

sleeve toward the screw head. Insert the screws into the holes you started. Tighten the screws until thesmall end of the mounting sleeve is flat aga

Occasionally, especially when you pick up the handset between rings, you may not be connected. If thishappens, press PHONE on the handset to connect

If you try to make a call when out of range, you will hear two short beeps when you press PHONE. Movecloser to the base, and press PHONE again to mak

Using the Intercom During a Phone CallFirst place the call on hold by pressing HOLD. Then use the intercom. While you are using the intercom,the Pho

To use the directory card concealed in the back of your handset, press the arrow and slide the door towardthe top of the handset until it snaps in pla

Answering System Operation: At The BaseAbout MailboxesThis answering system provides two voice mailboxes. These mailboxes provide a convenient way to

Pre-recorded AnnouncementIf you do not record your own announcement, callers will hear this announcement: “Hello. Please leave amessage after the ton