Att 915 Bedienungsanleitung

Big button t elephone 915Please also readPart 1 — Important product informationUser’s manual Part 2© 2006 Advanced American Telephones. All rights re

5. Connect the handset to the telephone.Plug the coiled cord into the handset jack on the left side of the base unit. Plug the other end of the coil

Make a callLift the handset. When you hear a dial tone, dial using the dial pad ormemory buttons.Answer a callWhen you hear the phone ring and thering

RedialThe last number dialed at this phone is stored in redial memory. To dial that number, lift the handset and listen for the dial tone, then press

Temporary tone dialingIf you have dial pulse (rotary) service, you can change from dial pulse to touch tone dialing during a call by pressing TONE *.

This telephone can store 13 telephone numbers, each up to 16 digits long. You can dial numbers stored in memory by pressing one or two buttons.Directo

12Store a pause in a memorynumberPress and release REDIAL/PAUSE once to store a three to four second pause in the dialing sequence. Each additional pr

To keep your phone working and looking good, follow these guidelines:• Avoid putting it near heating appliances and devices that generate electrical

REN 1.3BPower Four AA batteries are required forbacklighting. Phone must also beconnected to telephone line for allfeatures to work.Line feed voltage

15In case of difficultyIn case of difficultyIn case of difficultyIf you have difficulty operating this phone, try the suggestions below. For Customer

Telephone operationProblem SolutionProblem SolutionProblem SolutionLighted dial pad is dim or does not work• Make sure y

© 2006 Advanced American Telephones.All rights reserved.AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American

AAUDIO ASSIST™ 10BBatteries 2, 5, 16DLighted dial pad 2, 5Lighted dial pad is dim or do not work 16Difficulty storing numbers in memory 16Di

Before you begin ... 1Parts listInstallation... 2... 2... 5... 8...

Parts listYour box should include:1 Before you beginBefore you beginLong telephone line cordShort telephoneline cordCoiledhandset cordHandsetBase unit

InstallationTable/desk installation2InstallationInstallation1. Install batteries to provide power for the lighted dial pad. Press the battery cover

2. Set the t one/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the switch

5. Check for dial tone.Lift the handset and listen for a dial tone. If you cannot hear a dial tone, slide the VOLUME switch to the right. If you sti

Wall installation1. Install batteries to provide power for the lighted dial pad. Press the battery cover tab and remove the cover. Install four new

2. Set the tone/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the switch to