Att 1070 Bedienungsanleitung PDF herunterladen (Seite 71)

• Make sure your remote access code is correct

(see the installation guide for more details).

• If you access the extension mailbox through a

single page call, make sure the extension

number of the extension mailbox is entered

correctly.

• The extension mailbox is in use. Or the two

intercom paths are in use. Wait for a few minutes

then try again.

• There may be interference on the telephone line you

are using. Press the dial pad keys firmly when dialing.

The answering system

does not respond to

internal access commands.

If the telephone is not responding normally, try

the following (in the order listed):

1. Disconnect the power to the telephone base.

2. Disconnect the spare battery (if the set has

one).

3. Wait a few minutes before connecting power to

the telephone base.

4. Re-install the spare battery (if the set has one).

5. Wait for the telephone to synchronize its

connection. This may take up to one minute.

Common cure for

electronic equipment:

Appendix J

In case of difficulty

• Check the central (general) mailbox(es) for the

messages.

• Check Line Group setting (see page 43 of the

installation guide for directions).

Some messages for

specific extensions were

not recorded.

My phone beeps for no

reason.

• If someone is trying to assign your phone’s

extension number to another phone, your phone

will sound a warning beep, and display, “IS

ALREADY USED.”

1 2 ... 66 67 68 69 70 71 72 73 74

Keine Kommentare

Att 1070 Bedienungsanleitung Seite 71