Att CL82359 Bedienungsanleitung PDF herunterladen (Seite 45)

Answering system

About the answering system

New message indication

The message window on the telephone base flashes and

shows on the handset when there are new answering

system messages.

If the new message alert tone is turned on, the telephone

base beeps every 10 seconds when there are unreviewed

messages.

Call screening at the telephone base

If the answering system is on and the telephone base volume is not off (set

to 1 or higher), you hear the announcement and the incoming message when

receiving a call. If you want the telephone base to be silent while recording

messages, make sure you set the telephone base volume to 0.

Call intercept

While screening a call, you can stop recording and speak to the caller by

pressing PHONE

/FLASH or SPEAKER on the handset.

Base ringer

Press VOLUMEST on the telephone base to adjust the ringer volume when

the telephone is not in use.

You hear a sample of the ringer while adjusting the volume. The telephone

base announces, “Base ringer is off.” when you set the volume to 0.

Voice prompts

The system provides voice prompts to guide you through remote access and

recording outgoing announcements.

Temporarily turning off the message alert tone

Pressing any telephone base key (except HANDSET LOCATOR)

temporarily silences the message alert tone.

If you press XDELETE when in idle mode, there is a voice prompt to direct

you to press XDELETE again to delete all old messages, and the message

alert tone is temporarily off.

The message alert tone is re-activated with the next incoming message.

NOTE: If the answering system has less than five minutes of

recording time left, it announces the remaining time.

IBOETFU!2

21;32

22024

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 76 77

Keine Kommentare

Att CL82359 Bedienungsanleitung Seite 45